Limo blacked out windows look awesome. They also give some privacy and keep the temperatures down inside the car.

How easy is it to do it yourself? What tools do I need? Get some car window tinting tips from this article.

Regulations in most countries state that there is a certain amount of light transmitted through the window to the driver. This equates to no tints on the windscreen and often the front side windows or just a light tint.

It's a good idea to check your local regulations, sometimes these apply to vehicles of differing ages. Remember also that regulations can change so getting the darkest tint which is currently legal is not always the best option.

There is a lot more to tinting than the blackout film option. Pretty much any colour and grade of tint is available and even a selection of mirrored finishes.

The film comes in a number of forms and installation is usually much neater if done by a professional installer although it is possible to do a reasonable job at home. If you have a good quality window film and are prepared to take your time.

First off follow the instructions that come with the film, not all films require  heat and will not shrink to fit. Some Tinting films require that you coat the glass with an IPA solution and then put on the film. Getting this wrong for the sake of not reading the instructions can be a very expensive mistake.

Good preparation is the key,your work area needs to be dust free and clean. Tools required are a spray bottle filled with distilled water, heat gun, rubber blade or squeegee, good quality cloth - we recommend micro fibre or felt and a sharp craft knife or short blade. For most windows you will get a much better looking finish if you remove the rubber/plastic trim in accordance with your manufacturers instructions. (Don't forget to wind the door windows down slightly so the film touches the top of the glass because it looks unsightly otherwise when the window is wound down.)

Trim the window tint allowing for shrinkage when you apply heat. Clean the glass thoroughly then apply a mist spray of water then lay the film over the window.

Work from the top left corner working out the bubbles with the squeegee in a diagonal line across the window. Use the heat gun to shrink the film evenly to the glass and this causes the water to evaporate and gives a good adhesion. Patience is key, and you must avoid the temptation to un-peel and start over. Keep working away at the bubbles and they will go.

Trim off the excess and work the edges into the seams with the squeegee edge. Refit the plastic/rubber trim and you are finished, step back and admire.